forum.thequadshot.com
http://thequadshot.com/forum/

Can't get out of SOS but TX/RX are bound
http://thequadshot.com/forum/viewtopic.php?f=4&t=883
Page 2 of 2

Author:  Chris [ Wed Jan 08, 2014 7:47 pm ]
Post subject:  Re: Can't get out of SOS but TX/RX are bound

Do you have the Quadshot transmitter or do you have a Spektrum brand transmitter? If you bought a kit with the stock transmitter it should have come programmed to work with that transmitter only. If you switched out the stock receiver for a Spektrum receiver you will need to switch the baud rate.

Author:  Chris [ Fri Jan 10, 2014 2:17 am ]
Post subject:  Re: Can't get out of SOS but TX/RX are bound

Are the wires from the Lia to the receiver plugged in to the bind port on the receiver, or CH 1-6? It will only work in the bind port.

I have also seen a wire that was out of order; black white red, or something other than black red white.

Author:  Chris [ Fri Jan 10, 2014 9:20 pm ]
Post subject:  Re: Can't get out of SOS but TX/RX are bound

I will just send you one. Can I use the same shipping address as per your last order?

Author:  Chris [ Fri Jan 10, 2014 10:04 pm ]
Post subject:  Re: Can't get out of SOS but TX/RX are bound

No problem.

Through experience there is something different about the black wire. Make sure to tin it before soldering, even though it already appears to be tinned.

Page 2 of 2 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/