Help with espresso setup
Page 1 of 1

Author:  jeff2001 [ Mon Jan 20, 2014 6:19 am ]
Post subject:  Help with espresso setup

So I finally got around to building my espresso, awesome day of fun. Ran into some issues though.
1. Missing xbee usb carrier - will try source on locally here in south africa
2. Can't get the binding right.

I have two SPM9454 with a Spektrum DX7s .
When I bind the primary SPM9454 goes solid and the secondary goes blank.
I set the transmitter to DSM2.
LED's on Lisa\M are as follows
L1- Red flash
L2- Solid Green
LVIN - Solid Green
WingTips -SOS
I get no response from on the servos.

Any ideas would be welcome. Is there a walkthrough of the settings required on the transmitter anywhere. Do you choose heli or fixed wing for the model type ?


Author:  jeff2001 [ Sat Feb 15, 2014 6:54 am ]
Post subject:  Re: Help with espresso setup


Author:  Chris [ Mon Feb 17, 2014 7:33 pm ]
Post subject:  Re: Help with espresso setup

It is strange that one rx goes solid and one is blank. So does that mean that one is connected but there is no control (SOS)? The things I would check are the rx wiring and the baud rate.

Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group